Opel Frontera

since 1992 of release



Fronter's Opel
+ Opel Frontera brand Cars
+ Current leaving and service
- Engine
   Removal and OHC engine installation
   Removal and DOHC engine installation
   Engine dismantling
   Engine assembly
   Head of cylinders and valves
   Pistons and rods
   Block of cylinders
   Cranked shaft and bearings of a cranked shaft
   Camshaft drive
   Engine mounts
   Compression check
   Greasing system
   Works with system of greasing of the OHC/DOHC engine of 2.0 l
   Works with greasing system on the engine of 2.4 l
   Oil filter
   Oil radiator (if it is established)
   Pressure and oil temperature
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Manual box of gear shifting
+ Driveshafts, main transfer
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Governing bodies and operation
+ electric equipment Schemes




Oil filter

GENERAL INFORMATION

The filter is in the lower part of the oil pump. The filter represents a replaceable filtering element. The special key is applied to its removal. At installation of the filter oil a sealing ring and fix the filter so that to press a ring. In repair trucks the special natural is applied to an inhaling of the filter by dinamometrichesky control. Moment of an inhaling of the filter of 15 Nanometers.
Insert into a filter flute a new sealing ring, as is shown in иллюстр., having oiled it.
In the case of the filter there is perepuskny a valve. If necessary it can be replaced. The valve is under a stopper. To remove a stopper, it is necessary to drill an opening and to cut carving М10. Screw bolt М10 and pull out a stopper flat-nose pliers.
The new valve is pressed by an opravka in diameter of 15 mm in an opening against the stop.
After replacement of the oil filter check in system oil level even if replacement of the filter was made in the course of oil replacement. Fill the engine with the established amount of oil.