Opel Frontera

since 1992 of release



Fronter's Opel
+ Opel Frontera brand Cars
+ Current leaving and service
- Engine
   Removal and OHC engine installation
   Removal and DOHC engine installation
   Engine dismantling
   Engine assembly
   Head of cylinders and valves
   Pistons and rods
   Block of cylinders
   Cranked shaft and bearings of a cranked shaft
   Camshaft drive
   Engine mounts
   Compression check
   Greasing system
   Works with system of greasing of the OHC/DOHC engine of 2.0 l
   Works with greasing system on the engine of 2.4 l
   Oil filter
   Oil radiator (if it is established)
   Pressure and oil temperature
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Manual box of gear shifting
+ Driveshafts, main transfer
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Governing bodies and operation
+ electric equipment Schemes




Engine mounts

GENERAL INFORMATION

THE OHC ENGINE OF 2.0 L TO THE MIDDLE OF 1995. RELEASE

Left support of the engine Right support of the engine

Rubber support of the engine are made by various firms. All support of the engine should be only one manufacturer. For replacement of suspension brackets the engine is necessary for raising the load-lifting mechanism, having unloaded on support. Lifting of the engine is carried out by capture for eyes of a head of cylinders. After that bolts and rubber support turn away are disconnected from arms and a bridge beam.
The moments of an inhaling of elements of fastening of an engine mount see. Specifications.

THE OHC ENGINE OF 2.0 L FROM THE MIDDLE OF 1995. RELEASE


At this engine changes are made to a design of a suspension bracket. Forward support are shown on illustrations. For removal of support this engine is also necessary for raising.

Removal and installation of support are carried out as follows:

PERFORMANCE ORDER
1. Unscrew bolts of fastening of support from a beam.
2. Unscrew bolts of fastening of support from the chassis.
3. On the left side unscrew bolts of fastening and remove the heat-shielding screen from an engine support.

Installation of support is carried out in sequence, return to removal. It is necessary to maintain the moments of an inhaling specified in Specifications.

Removal and installation of a back engine mount is carried out as follows:

PERFORMANCE ORDER
1. Bring a support (1) from below under a cross-piece of a transmission (2) and a transmission.
2. Unscrew four bolts from outer side of a cross-piece of a transmission and two nuts of fastening in the center and remove a cross-piece.
3. Unscrew bolts and remove elements of fastening of the exhaust silencer from an engine support.
4. Unscrew two bolts of fastening of a suspension bracket to a transmission.

Installation of suspension brackets is carried out in sequence, return to removal. Thus it is necessary to maintain the next moments of an inhaling:

DOHC ENGINE


Replacement of engine mounts and a transmission is made according to instructions for the OHC engine from the middle of 1995 of release. Elements same suspension brackets.