Opel Frontera

since 1992 of release

Repair and car operation



Fronter's Opel
+ Opel Frontera brand Cars
- Current leaving and service
   Schedule of routine maintenance
   Current leaving
   Information on control
   Check of levels of liquids
   Check of a condition of tires and pressure in them
   Replacement of impellent oil and oil filter
   Check of level of liquid of system of hydrostrengthening of a wheel
   Rotation of wheels
   Check of a condition and replacement of hoses of an impellent compartment
   Condition check, adjustment of a tension and replacement of a driving belt (only for engines with tension adjustment)
   Check and adjustment of turns of idling of the engine and level WITH
   Check of a condition of the battery, care of it and charging
   Check and replacement of spark plugs
   Check and replacement of candle VV of wires, covers and distributor begunka
   Check of level of oil in a manual box of gear shifting and a transfer case
   Check of level of lubricant liquid of differential of forward and back bridges
   Check of fuel system
   Check of functioning of system of cooling
   Check of a condition of system of production of the fulfilled gases
   Check of a condition of components of a suspension bracket and steering
   Check of a condition of protective covers of power shafts of forward wheels
   Make check of brake system and replacement of brake liquid with the subsequent pumping
   Check of a condition and replacement of brushes of screen wipers
   Filling of a cooler of system of cooling
   Replacement of the fuel filter
   Replacement of the RKPP transmission oil and transfer case
   Replacement of lubricant liquid of differential of forward and back bridges
   Replacement of a distributive belt of the engine
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Manual box of gear shifting
+ Driveshafts, main transfer
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Governing bodies and operation
+ electric equipment Schemes



Check and adjustment of turns of idling of the engine and level WITH

GENERAL INFORMATION


Remark

The engine should be heated-up to normal working temperature, with correctly established corner of an advancing of ignition and the adjusted gaps of valves (where they are regulated). The air filter should be in a good condition, and all electric components (including air central air where it is available) should be switched off.


PERFORMANCE ORDER
1. Connect a tachometer and a measuring instrument WITH to the engine. Mechanics use special WITH - a tester which probe is established in the pipeline of system of release, but it is possible to use a usual tester which is inserted into an exhaust pipe. However pay attention that on models with the catalytic converter of exhaust gases on an exhaust pipe it is impossible to receive the correct indications of the contents WITH.
2. To adjust manually turns of idling it is impossible, as the stabilizing pneumovalve of idling is put in action by the electronic control unit. If at normal working temperature of the engine turns of idling do not correspond to the values specified in Specifications, check system of a fence of air on existence of leaks, and also operation of the stabilizing pneumovalve (see. Power supply system and release).
3. Verify measuring instrument indications WITH with the values given in Specifications. If adjustment is required, take a cap from a measuring instrument of an air stream and turn the adjusting screw before obtaining demanded value (on some models the six-sided key can be demanded). In summary establish a new protective cap.
Level adjustment WITH on Motronic system.