Opel Frontera

since 1992 of release



Fronter's Opel
+ Opel Frontera brand Cars
+ Current leaving and service
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
- Coupling
   Removal and coupling installation
   Coupling repair
   Coupling installation
   Coupling check without removal
   Mechanism of switching off of coupling
   Air removal from hydrosystem
   Adjustment of height and free wheeling of a pedal
+ Manual box of gear shifting
+ Driveshafts, main transfer
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Governing bodies and operation
+ electric equipment Schemes




Coupling installation

GENERAL INFORMATION

Coupling is established in sequence, return to its removal. Thus it is necessary to mean the following:

PERFORMANCE ORDER
1. At the removed coupling check the needle bearing in a cranked shaft (for a manual transmission).
2. Insert brackets as it was described above.
3. Establish on a flywheel a conducted disk according to "Getriebseite" marking - the transmission party.
4. If the coupling which was in the use is established, put it according to available marking. New coupling can be established in any situation.
5. The aligning opravka is applied to centering of a conducted disk (1) (иллюстр.). Centering in the presence of experience can be executed approximately. It is possible to use an old primary shaft for this purpose. Remember that not all models have an identical transmission.
6. Evenly tighten cross-wise bolts of fastening of coupling. Bolts М7 tighten the moment of 15 Nanometers, М8 the moment of 28 Nanometers. Thus it is necessary to hold a flywheel from a provorachivaniye. In certain cases Torx screws are applied to fastening. In the course of centering move forward and back an opravka that it did not jam.
7. After an inhaling of coupling take out three brackets. Sometimes they fall out at a coupling inhaling. At loss of brackets they can get in coupling. Watch that it did not happen.
8. Establish into place a transmission.