Opel Frontera

since 1992 of release

Repair and car operation



Fronter's Opel
+ Opel Frontera brand Cars
+ Current leaving and service
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Manual box of gear shifting
+ Driveshafts, main transfer
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Diagnostics of malfunctions of onboard electric equipment
   Safety locks
   Fusible inserts (thermal relays)
   Chain breakers (thermal relays)
   Relay
   Lighting devices
   Removal and installation of a sound signal
   Servomotor of adjustment of range of light
   Screen wiper
   Cleaner of back glass
   Electric circuits
+ Governing bodies and operation
+ electric equipment Schemes



Lighting devices

GENERAL INFORMATION

Headlights of Frontera provide a driving and passing beam. Lamps of a parking light settle down in the case of the main headlights.

REMOVAL AND INSTALLATION OF FILAMENT LAMPS OF HEADLIGHTS

PERFORMANCE ORDER
1. Open a cowl, wring out a spring latch from a reverse side of a headlight and uncover.
2. Rasstykuyte from a reverse side of a headlight the three-contact tip. Now the filament lamp withheld by a wire clip is visible.
3. Compress the clip ends, having removed it.
4. Take out a lamp, having taken it for contacts.
5. Take a new lamp a pure napkin. It is not necessary to take a lamp hands, on a lamp there can be traces.
6. A new dvukhnitevy lamp insert so that its fixing nouse on a socle entered into a groove of an opening of a reflector. Thus average of three contacts should be in the top part of a socle of a lamp.

Further assembly is carried out in sequence, return to removal. In summary it is necessary to check adjustment of headlights (as a rule, it does not change).

REMOVAL AND HEADLIGHT INSTALLATION

PERFORMANCE ORDER
1. In the presence of adjustment of range of light of headlights establish the adjustment switch in situation "0" and after that switch off a headlight.
2. Remove a front grille.
3. Rasstykuyte multicontact shtekerny connection of a lamp of a headlight from the interior of an impellent compartment (previously having uncovered).
4. In the presence of adjustment of range of light of headlights remove the servo-driver as it is described below.
5. Unscrew two bolts and take out a headlight from fastening in forward facing.

The headlight in sequence is established, to return to removal. Adjust the provision of a headlight.

HEADLIGHT ADJUSTMENT

Adjusting screws of a headlight are in the lower part. Access to them is carried out through openings in a front grille. The arrangement of both adjusting screws is shown on an illustration.