Opel Frontera

since 1992 of release



Fronter's Opel
+ Opel Frontera brand Cars
+ Current leaving and service
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Manual box of gear shifting
+ Driveshafts, main transfer
+ Brake system
- Suspension bracket and steering
   + Suspension bracket of forward wheels and forward bridge
   + Suspension bracket of back wheels and back bridge
   - Steering with the hydraulic booster
      Verifying and adjusting works on a steering
      Works on a steering drive
      Steering wheel and steering column
      Steering mechanism
      Pump of the hydraulic booster
      Safety cushion
+ Body
+ Onboard electric equipment
+ Governing bodies and operation
+ electric equipment Schemes




Verifying and adjusting works on a steering

GENERAL INFORMATION

INSTALLATION OF THE STEERING WHEEL

Exact adjustment of provision of a steering is carried out after installation of the steering mechanism and steering drafts or a steering column.

If steering drafts were replaced or regulated, it is necessary to measure the length of the "L" steering drafts shown on an illustration. On cars till 1995 of release this size should make 262 mm, on cars of later release the size is equal 299 mm.

PERFORMANCE ORDER
1. Sweep on the car and make sure that the steering wheel occupies the situation shown on иллюстр.
2. If the wheel is in other situation, remove it as it is described below, and put in the correct situation.

ADJUSTMENT OF THE FREE WHEELING OF THE STEERING WHEEL

At the working engine the steering wheel should move to the right and to the left on 10-30 mm. If люфт more specified, it is necessary to adjust a steering most or to hand over the car in a repair truck. At independent adjustment it is necessary to mean that this work is connected about safety of using by the car.

PERFORMANCE ORDER
1. Check a steering wheel on freedom of moving. For this purpose it move up and down and turn here and there. Excessive люфт not necessarily is a consequence of incorrect adjustment of a steering wheel.
2. Need of the appendix of the increased effort for turn of a steering wheel, turn by breakthroughs or aspiration turn in one certain party can to be eliminated with adjustment.
3. Establish a steering wheel in average situation as it is described above.
4. Weaken a lock-nut of the adjusting screw on the end of a steering shaft (the shooter on an illustration) and turn the screw to the right to reduce люфт. For increase люфта the screw turns to the opposite side.
5. Holding the adjusting screw, tighten a lock-nut the moment of 41 Nanometer.
6. Turn a steering wheel from one extreme situation in another. Jammings should not be.

AIR REMOVAL FROM HYDROSYSTEM

PERFORMANCE ORDER
1. At the idle engine unscrew a stopper of a tank and fill in liquid to "Max" mark.
2. Wait for not less than two minutes while liquid will not fill system.
3. Start the engine, let's to it work some minutes on single turns and stop. At this time not to rotate steering a wheel.
4. Again check liquid level in a tank and if necessary add.
5. Repeat the process described above until level of liquid will not be established at one level.
6. Lift a forward part of the car, having torn off wheels from the earth.
7. Start the engine and slowly turn a steering wheel from left to right so that carefully to bring it to an emphasis, but do not concern the last.
8. Watch liquid level in a tank and if necessary add.
9. Again lower the car on wheels and slowly turn a steering wheel in other party to other emphasis.
10. Stop the engine.
11. Check level of liquid and if necessary add.
12. If liquid at performance described above works strongly foamed, wait some minutes and repeat process of removal of air.