Opel Frontera

since 1992 of release



Fronter's Opel
+ Opel Frontera brand Cars
+ Current leaving and service
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Manual box of gear shifting
+ Driveshafts, main transfer
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Diagnostics of malfunctions of onboard electric equipment
   Safety locks
   Fusible inserts (thermal relays)
   Chain breakers (thermal relays)
   Relay
   Lighting devices
   Removal and installation of a sound signal
   Servomotor of adjustment of range of light
   Screen wiper
   Cleaner of back glass
   Electric circuits
+ Governing bodies and operation
+ electric equipment Schemes




Screen wiper

GENERAL INFORMATION

REMOVAL AND INSTALLATION OF LEVERS OF THE SCREEN WIPER

PERFORMANCE ORDER
1. Include and again switch off a screen wiper.
2. Note the provision of a stop of both brushes on the tape pasted on a windshield to establish them in former situation.
3. Remove a cap of a support of a screen wiper.
4. Unscrew the nut which was under it, remove a washer and the lever from a spindle. If necessary it is possible to use a small screw-driver. Watch to damaging a paint and varnish covering.

The lever in sequence is established, to return to removal. After installation check, that brushes occupied the former situation. On one lever the vetrootboynik is established.

REMOVAL AND INSTALLATION OF THE DRIVING ELECTRIC MOTOR AND DRAUGHTS

Electric motor

PERFORMANCE ORDER
1. Disconnect a weight cable from the storage battery.
2. Remove a bracket of fastening of a tank of cooling liquid and take out a tank.
3. Remove screen wiper levers as it is described above.
4. Remove a lattice from the air outlet channel to provide access to connecting bars of a screen wiper.
5. Rasstykuyte shtekerny connection of the electric motor.
6. Unscrew four bolts and remove the engine from an assembly frame.
7. Carefully insert a screw-driver under a crank and take out a finger of the spherical hinge

Installation

PERFORMANCE ORDER
1. At installation connect the crank lever to the spherical hinge.
2. Enter a crank through an air opening and fix the electric motor four screws.
3. Evenly tighten screws the moment of 9 Nanometers.
4. Before installation of levers of a screen wiper quickly switch on and off a screen wiper drive.
5. After that levers establish so that the size between the bottom edges of brushes and the bottom edge of a windscreen made 20 mm.

Drafts of a screen wiper

PERFORMANCE ORDER
1. After removal of the electric motor of a screen wiper unscrew five screws of fastening of a cover of the air channel and disconnect spherical hinges of levers of a screen wiper. Hinges fasten two nuts.
2. Unscrew five screws of fastening of drafts of a screen wiper and take out drafts and the hinge through an air opening.
3. Drafts can be disassembled. For this purpose remove drafts of spherical hinges. At assembly watch that spherical hinges were fixed.
4. If the crank acted in film from the electric motor, at installation it is necessary to check correctness of its situation. The fastening nut on an axis is tightened by the moment of 15 Nanometers.
5. Drafts in sequence are established, to return to removal. Nuts of drafts tighten the moment of 9 Nanometers.